Default Setting - Hama TS33C Mode D'emploi

Note
• The wireless transmission range
between the measuring and base
stations is up to 30 metres in open
spaces. Before installation, ensure
that wireless transmission will not be
disrupted by interference or obstacles
like buildings, trees, vehicles, high-
voltage lines, etc.
• Before the final installation, ensure
that there is sufficient reception
between the intended installation
locations.
• When installing the measuring station,
ensure that it is protected from direct
sunlight and rain.
• The international standard height for
measuring air temperature is 1.25 m
(4 ft) above ground.
Warning
• Buy special or suitable installation
material from a specialised dealer for
wall-mounting.
• Ensure that no faulty or damaged
parts are installed.
• Never apply force during installation.
This could damage the product.
• Before installation, ensure that the
chosen wall is suitable for the weight
to be installation, and make sure that
there are no electrical wires, water,
gas or other lines in the wall at the
installation site.
4
• You can position the measuring station
on a level outdoor surface using the base.
• We recommend installing the measuring
station securely on an outdoor wall.
• Install an anchor, screw, nail, etc. in the
wall of your choice.
• Hang the measuring station using the
opening intended for this purpose (5).
6. Operation

6.1. Default setting

• After opening the battery compartment,
first choose the channel using the
CHANNEL button.
• Only then, insert the batteries into the
battery compartment with the correct
polarity.
• Press the RESET button.
• Then replace the battery compartment on
the outdoor sensor.
6.2. Connection to the measuring
station
• To connect the measuring station and the
outdoor sensor, place the two devices as
close together as possible.
• After you insert the batteries, the base
station automatically searches for a
connection to the measuring station and
performs initial setup.
• If the device does not connect
automatically, the manual search
program on the base station must
be started.
Note
• Initial setup takes approx. 2 minutes.