Bluetooth Pairing - Hama SNAPDROP Mode D'emploi

• Charge the speaker fully before using it for
the first time.
• Connect the included Micro-USB charging
cable to the speaker's Micro-USB port (7).
• Connect the unused connector on the
Micro-USB charging cable to a suitable
USB charger. Please refer to the operating
instructions for the USB charger used.
• The status LED (8) lights up constantly in red
during the charging process.
• If the battery is fully charged, the status LED
(8) will go out.
Note – Charging
• It takes approx. 2 hours to completely
charge the product.
• The speaker's battery can be charged
whether the speaker is on or off.
• If the battery capacity is less than 10%,
the speaker will emit two acoustic
signals. You will only receive this
information if the speaker is on.
• The actual battery life varies depending
on use of the device, the settings and the
ambient conditions (rechargeable batteries
have a limited service life).
4

4.3 Bluetooth pairing

Note
• Check whether your mobile device (MP3
player, mobile phone, etc.) is Bluetooth
capable.
• Note that the maximum range for
Bluetooth is 10 metres without obstacles
such as walls, people, etc.
• Make sure that your Bluetooth capable
terminal device is on and Bluetooth
is activated.
• Make sure that the speaker is located
within the Bluetooth range of max.
10 metres.
• Switch on the speakers as described in
4.1 Switching the product on and off.
• The status LED (8) begins to flash. The
speaker searches for a connection.
• Open the Bluetooth settings on your
terminal device and wait until Hama
Snapdrop appears in the list of Bluetooth
devices found.
• Select Hama Snapdrop and wait until
the speaker is listed as connected in the
Bluetooth settings on your terminal device.
An acoustic signal confirms that connection
was successful.
• The status LED (8) now remains.