Table des Matières
Publicité
ENGLISH
2.3) Cutting
(Ref. to Fig. 5)
– Continue operating the pump, the blade (10) progressively advances, until the conductor
is completely cut in a clean and precise manner, without deforming the conductor itself.
Do not cut steel rods
2.4) Release of dies
– Release the oil pressure from the pump and fully retract the blade.
– By releasing the Locking Handle (17) the dies open and release the wire/conductor.
2.5) Inserting the die set
(Ref. to Figs. 1 e 2)
– Remove the locking pin (02) and insert the die set into
the top of the head and position the "locator" (A) in the
guide at the bottom of the head.
Ensure that the recess (B) on the front of the die set
faces the blade (10).
– Fully insert the locking pin (02) into the head.
The die set is polarised and can only be installed
one way, to allow the correct insertion of the locking
pin (02).
– To remove the die set from the head: open the locking
lever (17), completely remove the locking pin (02) and
slide the die set out of the head.
3. MAINTENANCE
The oil pressure in the head must always be completely released before discon-
necting the head from the hose.
All maintenance operations must be performed with the head disconnected from
the hydraulic pump hose.
The head is robust and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance
of the tool.
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Avoid putting the head on muddy or dusty ground. Any dirt particles may score the ram
and create oil leaks.
Every day, after use, the head must be cleaned with a clean cloth, taking care to remove
any residual particles, especially around the moving parts.
3.2) Storage
(Ref. to Fig. 6)
When not in use, the head should be stored and transported in the plastic case, to prevent
damage.
Plastic case: VAL P15: size 315x300x95 mm (12.4x11.8x3.7 in.); weight 0,93 kg (2 lbs).
The case is suitable for storing the head and up to 4 die sets.
FIG. 1
(B)
(A)
3
FIG. 6 STORAGE CASE
RANGEMENT
LAGERUNG
ALMACENAMIENTO
CUSTODIA
09
FIG. 7
BLADE CHANGING - CHANGEMENT DE LA LAME - MESSERWECHSEL
CAMBIO DE LA CUCHILLA - CAMBIO DELLA LAMA
20
10
21
Publicité
Table des Matières
