LD Systems CURV 500 Série Manuel D'utilisation page 10

SYSTEM IN CURV 500
33
Female 5-pin XLR socket to connect the CURV 500
NOTE: Use only shielded 5-pin XLR cables with parallel signal lines and full pin assignment. Some commercially available 5-pin XLR cables do not
necessarily possess the full pin assignment. When using a CURV 500
control panel of the LD CURV 500
PES Power Expansion Set to create a Stereo Set, the MONO / STEREO (26) switch on the mixer control panel must not be pressed down (STEREO).
500 ®
If an incoming stereo signal is present on INPUT LINE 3 / 4 of the LD CURV 500
34 SYSTEM OUT CURV 500 SE
Male 5-pin XLR socket to connect an additional CURV 500
35 POWER LED
Lights up once the system is properly connected to the power mains and switched on.
POWER CONNECTOR WITH FUSE HOLDER
36
IEC power socket with built-in fuse holder. A suitable power cord is included in the delivery. IMPORTANT INFORMATION: Replace the fuse only with a
fuse corresponding to the operating voltage. Please observe the label on the housing. If the fuse blows repeatedly, please contact an authorised
service centre.
POWER ON / OFF
37
On / Off switch for the power supply of the device.
38 SATELLITE OUT RIGHT
Speakon-compatible output for controlling one to four LD CURV 500
combination of LD CURV 500 ® ES and LD CURV 500
control of the LD CURV 500 ® satellites on the left. The LD CURV 500
SE (SATELLITE OUT RIGHT).
subwoofer LD CURV 500 ®
39 RELEASE BUTTON
satellite (LD CURV 500
Now slide a CURV 500 ®
spring-loaded release button on the side of the satellite. Ensure that the two guide rails of the satellite (40) properly slide into the grooves (41) of
adapter or of the lower satellites, in order to ensure a tight fit and establish a contact for both components. Now release the button
the SmartLink ®
to lock the connection and to bring the button back to its original position. Proceed in the same manner as described above to add other satellites.
40 GUIDE RAIL LD CURV 500 SATELLITE
41
GROOVES SMARTLINK ® ADAPTER OR LD CURV 500 SATELLITE
41
39
40
10
S Subwoofer (SYSTEM OUT Nº 6 -> SYSTEM IN Nº 33). A suitable 5-pin XLR system cable is included.
®
S Subwoofer must be pressed down (MONO). An incoming audio signal will be mono summed. When using a CURV
®
® SE Subwoofer expansion, or the CURV 500
PES) requires the use of the satellite output LEFT (left) on the LD CURV 500
®
®
SAT) from the rear onto the SmartLink
®
41
42
40
SE as a subwoofer expansion, the MONO / STEREO (26) switch on the mixer
®
® S Subwoofer, it will be output in stereo.
® PES Power expansion sets.
® satellites. The use of the LD CURV 500
satellites on the right are controlled by the satellite output of the expansion
adapter (LD CURV 500
®
44
43
41
PS Power Set as a Stereo Set (or the
®
® S Subwoofer for the
SLA) until it stops, while pressing the
®
44
43
41