Environmental Protection - Evolution EB225DWSHH Manuel D'instruction

BUILD ®
Checking and replacing the
Carbon Brushes
WARNING: Disconnect the machine from
the power supply before attempting to
check or replace the Carbon Brushes.
To remove the brushes:
• Unscrew the 2 plastic caps found
towards the base of either side of the
motor housing. Be careful as the caps are
spring-loaded.
1
• You must replace both carbon brushes
if one has less than 6mm length of
carbon remaining, or if the spring or wire
is damaged or burned.
• Withdraw the brushes with their springs.
• If replacement is necessary renew the
brushes and replace the caps.
• Ensure the caps screw back freely.
Note: Used but serviceable brushes can
be replaced, but only as long as they are
returned to the same position, and inserted
the same way round, as they were removed
from the machine.
• Run new brushes without load for
approximately 5 minutes. This will help
the bedding-in process.
16
To replace the Power Driven Backing Pad
WARNING: Only attempt this procedure
with the machine disconnected from the
power supply.
• Remove any installed sanding disc to
• Holding the Backing Pad with the palm
2
Fig. 11
• Remove the socket headed screw and
Note: The two (2) flats machined on the
power spindle that engage in the Backing
> 6mm
Pad to provide positive drive and location.
(Fig. 12)
Fig. 12
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.
www.evolutionbuild.com
reveal the Backing Pad and the centrally
located socket headed screw that
attaches it to the power drive spindle.
of one hand, loosen the socket headed
screw using the supplied 5mm Hex Key
with the other hand. (Fig. 11)
lift away the Backing Pad.

ENVIRONMENTAL PROTECTION

UK