Evolution EB225DWSHH Manuel D'instruction page 13

Ponceuse de cloisons séches à main de 225 mm
Masquer les pouces Voir aussi pour EB225DWSHH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To remove an Abrasive Sanding Disc:
• Lift the abrasive disc at any point along
its edge, and gently peel upwards and
away from the Backing Pad.
To switch the machine 'On':
• Press the Trigger Switch. (Fig. 5A)
Note: For operator convenience the On/Off
Trigger Switch can be locked in the
'On' position.
• Push in the 'Trigger Locking Button' (Fig. 5B)
to lock the Trigger in the 'On' position.
B
A
Fig. 5A +B
To switch 'Off':
• Press the Trigger slightly and then release.
The Power Rated speed Control (Fig. 6)
Rotate the thumb wheel until the required
rated speed is obtained.
Fig. 6
Sanding Head Suction Regulator Control
(Fig. 7)
Fig. 7
The Suction Control Regulator allows the
operator to adjust the power of the suction
provided by the inbuilt dust extraction system.
Extra air can be allowed into the Sanding
Head, reducing the suction power. This may
be necessary as at maximum suction the
Sanding Head may become difficult to move
or sweep over the work surface. Regulating
the volume of air admitted to the Sanding
Head can reduce operator workload by
reducing the effort required to sweep the
Sanding Head over the work surface.
To adjust the suction:
• Rotate the Regulator counter clockwise
fully, for reduced suction.
• Rotate the Regulator clockwise fully for
maximum suction.
Note: The Regulator has three (3) positive
stop positions.
The Sprung Sanding Head
The Sanding Head is attached to the
machine by four (4) sprung loaded pins.
This allows the Sanding Head to move
slightly in multiple directions.
When in use the Sanding Head can
effectively 'float' over the work surface
compensating automatically for uneven
wall surfaces. This action enables the user
to sweep the work surface with minimal
changes to their stance and foot position,
allowing greater security and better balance
for the operator.
www.evolutionbuild.com
HAND HELD DRYWALL SANDER
13

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

R7235aR7235b

Table des Matières