Télécharger Imprimer la page

Lindy 38139 V2 Manuel Utilisateur page 6

70m cat.6 hdmi 10.2g & ir hdbaset avec poc

Publicité

Les langues disponibles

Les langues disponibles

User Manual
Installation and Operation
Transmitter Front and Rear
1. Power LED: Indicates Power.
2. 24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the transmitter
or receiver. This is only required at one side of the installation.
3. HDBaseT Out: HDBaseT output port. Connect a compatible HDBaseT receiver using a single Cat.6
or above cable for all data signals. Please do not connect to a network port.
4. HDMI In: Connect to an HDMI source device.
5. IR In: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being
used is within the direct line-of-sight of the IR Extender.
6. IR Out: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR
Transmitter in direct line-of-sight of the equipment to be controlled.
7. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection
for the pass-through transmission of RS-232 commands.
8. Link Indicator LED:
a. Illuminated Green: Link is Okay
b. Not Illuminated: No Link
9. Data Signal Indicator LED:
a. Illuminated Orange: Signal is Okay
b. Not Illuminated: No HDMI Signal
Receiver Front and Rear
1. Power LED: Indicates Power.
2. 24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the transmitter
or receiver. This is only required at one side of the installation.
3. HDBaseT In: HDBaseT Input Port. Connect a compatible HDBaseT transmitter using a single Cat.6
or above cable for all data signals. Please do not connect to a network port.
4. HDMI Out: Connect to an HDMI display.
5. IR In: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being
used is within the direct line-of-sight of the IR Extender.
6. IR Out: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR
Transmitter in direct line-of-sight of the equipment to be controlled.
7. RS-232: Connect to a PC, Serial Controller or Serial device via phoenix block 3-way connection
for the pass-through transmission of RS-232 commands.
8. Link Indicator LED:
a. Illuminated Green: Link is Okay
b. Not Illuminated: No Link
9. Data Signal Indicator LED:
a. Illuminated Orange: Signal is Okay
b. Not Illuminated: No HDMI Signal
Important! Before starting the installation, please ensure that all devices are powered off.
English

Publicité

loading