Input Level - Kicker IQ Série Mode D'emploi

INPUT LEVEL: The RCA inputs on KICKER IQ amplifi ers are
capable of receiving either Hi or Low-level signals from a source unit.
GAIN: The input gain control is not a volume control. It matches the
output of the source unit to the input level of the amplifi er. Turn the
source unit up to about 3/4 volume. Next, slowly turn the gain up
until you can hear audible distortion, then turn it down a little.
X-OVER: Use the XOVER switch(es) on the end panel of the
amplifi er to set the internal crossovers to OFF, HI, or LO. When the
switch is set to OFF, a full bandwidth signal will be amplifi ed. Set the
switch to HI if you want the amplifi er's internal crossover to serve
as a high-pass fi lter. Set the switch to LO if you want the amplifi er's
internal crossover to serve as a low-pass fi lter.
FADER: Turn on the FADER switch if you are running two sets of
inputs to the amplifi er. Leave the fader switch OFF if you want to
drive all channels from a single stereo input.
KICK EQ: Adjust the bass boost from 0–18dB, centered at 40Hz.
PANEL LOCK: When active (LED ON) the amplifi er is using the
settings from the Tweeq software. When it is not active (LED OFF)
the amplifi er is using the end panel controls.
GUI: Connect to your computer or tablet and run the KICKER
TWEEQ software for real-time control of your amp's DSP.
2015 IQ Quick Start Rev C.indd 9 2015 IQ Quick Start Rev C.indd 9
9
12/4/2014 1:29:54 PM 12/4/2014 1:29:54 PM