Gardigo 60090 Notice D'utilisation page 12

Note: As it is not possible to hear the ultrasonic frequencies, there might be doubts if
the device is working when using the ultrasonic frequencies only (ON2). To check this,
switch to mode (ON1). If the LEDs flash, then the batteries are sufficiently charged and
the device is emitting an ultrasonic sound.
Changing the batteries:
After a length of time it can happen that the capacity of the rechargeable battery is
reduced and it is necessary to exchange it. Please use a Mignon LiFeP04 (AA), 3,2V with
500 mAh (available in the Gardigo Shop www.gardigo.de, Art. Nr. 50012). The exchange
of batteries is relatively simple but the device needs to be opened. Pay attention to
the polarity. The minus end of the battery always connects to the spring in the battery
compartment.
If you are not familiar with opening technical devices, please ask an expert for help.
6. Specifications
• Charging: Solar panel 4,8V, 50mA
• Battery: 1 x Lithium-Iron-Phosphate Mignon (LiFeP04) Mignon (AA), 3,2V, 500mAh
(available in Gardigo Shop www.gardigo.de, Art. Nr. 50012)
• Frequency: 23 – 50 kHz +/– 10 %, max. 75 dB
• Area coverage: 7 m diameter
• Power-LED: white Flash
• Speaker: 1 piezoelectric speaker
• Control element: 3 way: (ON/OFF), ultrasonic, ultrasonic/flash
• Operating temperature: 0 °C to + 50 °C and ≤ 90 % R.H.
• Storage temperature this: 0 °C to + 50 °C and ≤ 90 % R.H.
7. General information
• The CE conformity has been proven and the declarations are deposited with us.
• For safety and conformity reasons it is not permitted to rebuild or modify the device
and/or use it in any other way than described above.
• This device has a warranty of two years. As Gardigo has no control of the correct of
appropriate installation and use of the device the warranty can only be applied to a
fully equipped device in prime condition. We assume neither warranty nor liability
12