Witter F111A Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-1
D 4 M10 x 1.5mm Nuts, Lock Washers and Flat Washers (25mm O.D.)
E 1 Right Hand Side Arm
F 2 Spreader Plates with captive bolts
G 1 Left Hand Side Arm
H 4 M12 x 35 x 1.75mm Bolts, Nuts and Lock Washers
I 1 ZEP35 Electrical plate (not shown)
CB 2 M16 x 50mm Coupling Bolts, Nuts, Lock Washers
FITTING
Remove bumper (2 wheel arch liner screws and 1 nut behind wheel arch liners each side. 2 fixings on top edge of
1
bumper and 2 fixings on lower face of bumper). Remove bumper beam.
Insert Spreader Plates (F) into chassis rails with the captive bolts through existing holes in outside face of chassis.
2
Loosely attach Side Arms (E) and (G) to captive bolts on Spreader Plates (F) using Nuts (D).
3 Replace bumper beam and bumper.
Loosely attach Cross Bar (A) to Side Arms (E) and (G) using Bolts (H). Tighten all Bolts.
4
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
W0001F111A-FIT$010802220000pÄ
W0001F111A-FIT$010802220000
TOWBAR
F111A
For FORD FOCUS 2
ESTATE
2005 -