Installing Remote Control Batteries; Using The Remote Control - Insignia NS-A3111 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Insignia NS-A3111 DVD Executive Shelf System
#
Button
Function
7
Press to skip backward or forward to
or
the previous or next chapter or track.
8
BOOKMARK
Press to open the Bookmark menu.
9
V-SELECT
Press to switch between video outputs.
10
ZOOM/CLEAR
In playback mode, press to select a diff
erent zooming size while playing a
video.
In menu mode, press to clear the
information you entered in a setup
menu.
11
ANGLE/PBC
In playback mode, press to toggle
between different angles to view (if
available on the disc).
Press to turn PBC on or off on a VCD
disc.
12
SOURCE
Press to cycle between Disc/USB, FM,
AM, and AUX modes.
13
ROTATE
Press to rotate the picture.
14
CLOCK
In Standby mode, press and hold to
start real time clock setup.
15
SLEEP
Press to activate a sleep timer for your
DVD shelf system to go into standby
mode automatically.
16
OPEN/CLOSE
Press to open and close the disc tray.
17
VOL +/VOL –
Press to increase or decrease the
volume.
18
MUTE
Press to mute the sound. Press again
to restore the sound.
19
INFO
Press to display current information
about a disc during playback.
20
Press once to pause playback or
(Pause)
recording. Press repeatedly to advance
frame by frame.
21
Press to start playback.
(Play)
22
SETUP/EXIT
Press to enter or exit the System Setup
menu.
23
OK
Press to enter or select a value in a
menu and setup navigation.
24
In playback mode, press to fast reverse
/
or fast forward the DVD or CD. Press
repeatedly to step through the fast
reverse or fast forward speeds.
In Radio mode, press to start autoscan
up or down.
25
SUBTITLE
Press to select a subtitle language, if
available.
26
AUDIO/FM ST
In playback mode, press to change to a
different audio stream.
In radio mode, press to select Mono or
Stereo.
#
Button
27
DIMMER
28
GOTO
29
PLAYMODE
30
A-B
31
EX BASS
32
EQ

Installing remote control batteries

To install the remote control batteries:
1 Remove the battery cover.
2 Insert two AAA batteries into the battery
3 Replace the cover.

Using the remote control

To use the remote control:
www.insignia-products.com
Function
Press to dim or brighten the front panel
display light.
Press to start playback at a specific
point on a DVD, CD, VCD, or SVCD
disc.
Press to display the playmode menu to
select a different play mode.
Press to set up repeat playback or to
clear repeat playback.
Press to turn Ex Bass on or off.
Press to select a preset EQ mode.
Selections include FLAT, ROCK, POP,
CLASSIC, and JAZZ.
compartment. Make sure that you match the
+ and – symbols on the batteries with the +
and – symbols in the battery compartment.
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• If the remote control is not going to be used for
an extended period of time, remove the
batteries.
Point the remote control directly at your shelf
system, within a 60° angle horizontally (30°
to either side), and within 30° vertically of the
remote control sensor on the front of your
shelf system and within approximately 20 feet
(6 m) of your shelf system.
Caution
Do not expose the remote control to liquids, direct
sunlight, or shock. Do not mix batteries of different
types.
7

Publicité

Table des Matières
loading

Table des Matières