LaserLiner PrecisionPlane-Laser 3D Pro Mode D'emploi page 21

9
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at great distances or
when the laser lines are no longer visible. To work with a laser receiver, switch
the line laser to hand-held receiver mode by keeping button 14 (hand-held
receiver mode on / off) pressed. The laser lines will now pulsate with high
frequency, making the laser lines darker. The laser receiver can detect these
pulsating laser lines.
1 sec.
!
Observe the laser receiver's operating instructions for line lasers.
Due to the special optics required to generate a continuous 360° laser
!
line, the underlying technology may cause differences in brightness in
different areas of the line. This may lead to different ranges in hand
receiver mode.
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
PrecisionPlane-Laser 3D Pro
21
EN