Installation Procedure - Toto Aquia TS416A Manuel D'installation Et D'utilisation

NO TE: Be sure to thoroughly clean and remove all debris from the water supply pipe
before it is installed. This will prevent clogging in the spray outlet.
INSTALLING MODEL TS416A(R):
1) Slide the escutcheon onto the
shower arm (see Illustration 1).
2) Wrap pipe tape around the threads
of the shower arm and fasten it to the
supply elbow (see Illustration 1).
3) Thread the showerhead onto the
shower arm until it is tight (see
Illustration 1).
4) Slide the escutcheon until it is flush
against the wall (see Illustration 2).
NO TE: Do not use the showerhead as
leverage to tighten the shower arm.
This can damage the showerhead.
INSTALLING MODEL TS624A:
1) Slide the escutcheon onto the shower
arm (see Illustration 1).
2) Wrap pipe tape around the threads
of the shower arm and fasten it to the
supply elbow (see Illustration 1).
3) Loosen the two set screws at the
top of the ball joint. Ensure that the
gasket is in place in the ball joint,
then thread the shower arm onto the
showerhead until it is tight and secure
it by tightening the set screws (see
Illustration 1).
4) Slide the escutcheon until it is flush
against the wall (see Illustration 2).
NO TE: Do not use the showerhead as
leverage to tighten the shower arm.
This can damage the showerhead.

INSTALLATION PROCEDURE

Illustration 1
Shower Arm
Illustration 2
Illustration 1
Shower Arm
Set Screw
Showerhead
Illustration 2
5
Pipe Tape
Escutcheon
Filter & Gasket
Showerhead
Escutcheon
Escutcheon
Escutcheon