Festool LHS-E 225 EQ Notice D'utilisation D'origine page 20

GB LHS-E 225
Problem
LHS-E 225 not working
LHS-E 225 not working
and beeps three times
when an attempt is made
to switch it on
If problems other than those listed occur, please contact your Festool service workshop or your local spe-
cialist dealer.
Information on data protection
The power tool contains a chip which automatically stores machine and operating data (RFID). This data
saved cannot be traced back directly to an individual.
The data can be read using special (contactless) devices and shall only be used by Festool for fault diagno-
sis, repair and warranty processing and for quality improvement or enhancement of the power tool. The
data shall not be used in any other way without the express consent of the customer.
20
Possible causes
plug it is not connected correctly. Check that the plug it is securely con-
Interruption to power supply
Overheating protection active
Remedy
nected.
Switch the power tool off and on again.
Let the power tool cool down for approx.
15 minutes before switching it back on
again.