Advice For Operation; After Use; Routine Maintenance; General Information - GGP ITALY TR 24 Li Manuel D'utilisation

nylon line against the trunk of bushes or trees
with soft bark could seriously damage the plant.
6.4.2 Adjusting the length of the
cutting line head during work
Head line length should be adjusted:
– when the line is consumed
and becomes shorter;
– when motor rotation seems
higher than normal;
– when cutting efficiency seems reduced.
• Automatic line release
This machine is fitted with an
automatic line release head.
To release new line:
1. Stop the machine (par. 6.6);
2. wait for two seconds and restart the machine.
The released line is about 6.35 mm.
Repeat the procedure until the line
length reaches the line cutting knife
that will cut any exceeding length.
• Manual line release
To release new line:
1. Stop the machine (par. 6.6);
2. remove the battery from its
housing (par 7.2.2);
3. press the button on the line head (Fig.
19.A) and, at the same time, pull the line
manually for the length that is necessary
to reach the line cutting knife (Fig. 19.B);
4. bring back the machine to
the working position;
5. Fit the battery inside its housing (par. 7.2.3).

6.5 ADVICE FOR OPERATION

During use it is best to periodically remove
weeds that wrap around the machine to avoid
motor overheating (Fig. 1.A), due to grass caught
under the cutting means guard (Fig. 1.D).
Proceed as follows:
– stop the machine (par. 6.6);
– remove the battery (par.7.2.2);
– wear work gloves;
– remove the caught-up grass with
a screwdriver to allow the motor
to be properly cooled.
6.6 STOP
To stop the machine:
1. Release the throttle control lever
2. Wait until the cutting means stops.
machine, it will take a few seconds
for the cutting means to stop.
IMPORTANT Always stop the machine
when moving between work areas.

6.7 AFTER USE

• Remove the battery from its housing
and recharge it
• Allow the motor to cool before
storing in an enclosed space.
• Clean (par. 7.3).
• Check there are no loose or damaged
components. If necessary, replace the
damaged components and tighten
any screws and loose bolts or contact
the authorised service centre.
IMPORTANT Always remove the
battery (par 7.2.2) whenever you leave
the machine unused or unattended.

7. ROUTINE MAINTENANCE

7.1 GENERAL INFORMATION

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
maintenance operation, you need to:
• Stop the machine;
• remove the battery from its housing
and
• allow the motor to cool before
storing in an enclosed space;
• use suitable clothing, protective
gloves and goggles;
• read the relevant instructions;
– The frequency and types of maintenance
(Fig. 10.A);
– The use of non-genuine spare parts and
EN - 12
When you have stopped the
(par 7.2.2).
Prior to carrying out any
recharge it (par 7.2.2).
are summarised in the "Maintenance Table"
(chapter 13). The table will
your machine's safety and performance.
It summarises the main interventions to
be made and the frequency applicable to
each of them. Carry out the relevant task as
soon as it is scheduled to be performed.
attachments could adversely affect machine
operation and safety. The manufacturer
help you maintain