Fitting The Guard On The Cutting Means; Fitting The Indicator On The Cutting Limit; Throttle Control Lever; Throttle Safety Lever - GGP ITALY TR 24 Li Manuel D'utilisation

1.b Model TR 24 Li
– Insert the front hand grip (Fig. 6.A) on the
pre-assembled support (Fig. 6.B), with the
seat of the screw oriented on the right side.
2. Insert the screw and tighten the knob,
without tightening it (Fig. 5.C, Fig. 6.C).
3. Adjust the grip in the most ergonomic
position for the operator (chapter 6.1.2).
4. Tighten the knob.
4.4 FITTING THE GUARD ON
THE CUTTING MEANS
Wear protective gloves.
Every cutting means must
be fitted with a specific guard, as
indicated by the following directions
in the Technical Data table.
1. Place the guard (Fig. 7.A) on the holes
on the power unit base (Fig. 7.B).
2. Secure the guard (Fig. 7.A) fully
tightening the screws (Fig. 7.C).
NOTE On the guard of the cutting
means there is the following symbol:
4.5 FITTING THE INDICATOR ON
THE CUTTING LIMIT
1.a Model TR 24 Li B
– Insert and fasten the two ends of the cutting
limit indicator (Fig. 8.A) in their respective
holes on the power unit (Fig. 8.B).
1.b Model TR 24 Li
– Slightly enlarge the cutting limit indicator
(Fig. 9.A) and insert it in the space
provided on the power unit (Fig. 9.B).
5. CONTROLS

5.1 THROTTLE CONTROL LEVER

It allows to start/stop the machine
and simultaneously engages/
disengages the cutting means.
Indicates the rotation
direction of the
cutting means.
The throttle control lever (Fig. 10.A). can
only be used if the throttle safety lever is
pressed simultaneously (Fig. 10.B).
For machine start up:
– Simultaneously push the regulator
control lever and safety lever.
Starting the machine causes the cutting
means to start rotating at the same time.
The machine stops automatically as the
throttle control lever is released.

5.2 THROTTLE SAFETY LEVER

Throttle safety lever (Fig. 10.B) allows the
throttle control lever to be used (Fig. 10.A).

6. USING THE MACHINE

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
6.1 PREPARATION
Before starting work
several checks and operations to ensure you
can work efficiently and in maximum safety:
1. make sure the battery is not
inserted in its housing;
2. place the machine in a stable
horizontal position on the ground;
3. adjust the cutting diameter (par. 6.1.1)
4. adjust the machine from the ergonomic
and functional points of view, in order to
adapt it to the worker stature and to the
type of work
5. check the battery (par. 6.1.7).
6.1.1 Adjustment of the cutting diameter
(for cutting in motion only)
It is possible to set up a more or less wide
cutting diameter (30 cm or 25 cm).
A larger cutting diameter helps to complete
the work more quickly and it should be
used in case of greater time to work.
A smaller cutting diameter optimises
operating time and cutting speed.
To set the cutting diameter smaller:
EN - 9
it is necessary to carry out
(par. 6.1.2 - par. 6.1.6);