Vanquish Installation - Martin Logan Vanquish Mode D'emploi

VANQUIsH INsTAllATION

Recommended tools:
• Stud finder
• Sharp pencil or pen
• Pushpin
• Dry wall knife/saw
• Wire strippers
• Phillips screwdriver or electric drill and bit
• Tape measure
• Low-tack tape
1. Using a stud finder, position the template so it is
centered between wall studs or ceiling joists.
2. Hold or pin the template in place and mark
cutout with a pencil.
3. Remove the template and cut out the opening
with a drywall knife/saw.
4. Place fiberglass insulation 12" (30cm) or thicker
between the joists directly above the speaker.
5 Connect speaker cable. Be consistent when
connecting speaker leads to the terminals on
the speaker. Take great care to assign the
same color to the (+) terminal on both the
speaker and the amplifier.
WARNING! Turn your amplifier
off before making or breaking any
signal connections!
6 Place speaker in hole.
7 Orient the tweeter so it is pointing towards the
primary listening position. Use a 2-inch long
#2 Phillips driver and an electric drill. While
holding the speaker in position by the installa-
tion handle, for each set of screws tighten both
screws alternating between either screw until
the mounting lock has moved firmly into place.
8
8 Loosen wing nuts and remove the installation
handle.
9 Adjust the position switches. For a center chan-
nel application, set the 'Center Channel /
Front or Surround' switch to 'Center Channel'.
For a front- or surround-channel application,
set the 'Center Channel / Front or Surround'
switch to 'Front or Surround' and choose the
appropriate position setting on the 2nd switch.
Please Note: When the 'Center Channel
/ Front or Surround' switch is set to 'Center
Channel' the 2nd switch setting is irrelevant.
10 Remove the protective sticker that is covering
the Folded Motion tweeter.
11 Place the magnetic grill cover over the speaker.
Fig. 7 Vanquish