Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
26
11. Residual Risk
During the design phase, CARAT CENTRAL BV
paid particular attention to the aspects that may
generate risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION!
•
Danger of presence of electric current:
The machine has an internal electric system.
CONNECT THE MACHINE TO A SYSTEM
WITH DIFFERENTIAL PROTECTION AND
EFFECTIVE EARTH WIRE.
CAUTION!
•
Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR
DEFENDERS.
CAUTION!
•
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE
GOGGLES.
CAUTION!
•
Danger of accidental contact with the moving
tool.
OPERATORS
MUST
PROTECTIVE GLOVES
WEAR
HEAVY
49
ALWAYS STAY IN THE WORKING POSITION
(Pos. 1 picture 18) DURING THE MACHINE
OPERATION PHASES:
-
During material loading;
-
During material cutting;
-
During the cutting tool deceleration following the
machine stop.
12. Maintenance
CAUTION!
BEFORE PERFORMING ANY OPERATION OR
ADJUSTMENT, DISCONNECT THE MACHINE
FROM THE SUPPLY MAINS.
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with two registers
for the motor head vertical play adjustment.
For correct adjustment, proceed as follows:
-
with a 3 mm Allen wrench, screw both front
adjustment dowels (A), until the play is
eliminated (see picture 27);
27
-
repeat the operation for both back adjustment
dowels (B) (see picture 28).
28
GB
Publicité
Table des Matières
