Carat P-7010 Mode D'emploi page 47

21
A
4) Repeat the procedure on the end cut carriage
stopper.
CAUTION!
WHEN THE CUT LENGTH IS MODIFIED, WATER
COMES OUT FROM THE MACHINE.
Model P-7010
Perform only operations 1, 2 and 3.
CAUTION!
DO NOT MODIFY THE CUT END CARRIAGE
STOPPER POSITION
EQUIPPED WITH LASER MARKER
9. Cutting a surface at 45°
CAUTION!
Before positioning the motor head, make sure that:
- the machine is off ;
- the cutting tool is not moving;
45° CUT
Referring to the graded scale located on the
machine upright, move the motor head to the jolly
position and tighten the knobs (see picture 22).
B
FOR THE MODELS
22
- Position the piece to be cut on the working table
and perform the cutting operation.
23
LASER MARKER
CLASS IIIA LASER INSTRUMENT
By means of the laser marker accessory, the cutting
operations can be accelerated.
As a matter of fact, the special laser system is able
to indicate the tool cutting line on the working table.
CAUTION!
THE LASER MARKER STARTS WORKING
ONCE THE MACHINE IS CONNECTED TO THE
POWER SUPPLY.
CAUTION!
DIRECT EXPOSURE TO SUNLIGHT MAY REDUCE
THE LASER MARKER EFFECTIVENESS.
IT IS THEREFORE ADVISABLE TO USE THE
MACHINE INDOORS.
47
CAUTION!
GB