Carat P-7010 Mode D'emploi page 44

GB
f) With a 6 mm Allen wrench, remove the blade
cover locking screw (see picture 10).
g) Turn the blade cover and lock it with the screw
that had been previously removed.
10
h) Engage the water hose on the water on-off valve
(see picture 11).
11
i) Insert the tube-holder
(see picture 12).
12
l) With the 5 mm Allen wrench, put the cut start
carriage stopper in position A, as shown in
picture 13.
rod in its seat
44
13
m) Put the additional splash guard in working
position (see picture 14).
14
CHECKING BEFORE USE
CAUTION!
THE P-7010 MACHINE HAS BEEN DESIGNED
FOR WORKING EXCLUSIVELY WITH WATER.
15
- Before any cutting operation, make sure that the
water level inside the tank is correct.