Carat P-7010 Mode D'emploi page 38

GB
"TRANSLATION OF THE ORIGINAL INSTRUCTIONS"
1. Purpose of this Manual
This manual is an integral part of the machine.
It was produced by CARAT CENTRAL BV to provide
those authorised to work with the machine with the
information required for its foreseeable lifespan.
Before starting to use this machine read the safety
chapter carefully.
Each machine is subjected to a series of tests and
carefully checked before leaving our factory.
CARAT CENTRAL BV is constantly striving to
develop their machines and therefore reserves
the right to make any change without prior notice.
Therefore, no claims may be made on the basis of
the data and illustrations contained in this manual.
2. Safety information
• The manufacturer accepts no responsibility
where the P-7010
any tools other than those specifi ed in
the "RECOMMENDED
DO NOT USE WOODEN DISCS.
DO NOT USE DRY-CUTTING DISCS.
• P-7010 is made to operate exclusively under
the conditions indicated under "TYPE OF
OPERATION ALLOWED", in the "TECHNICAL
DATA" paragraph.
• During cutting operations, allow the machine to
rest as indicated.
• P-7010 is not made for use with a continuous
load.
• ALWAYS TEST THE ROTATION DIRECTION
WITH THE CUTTING
CAUTION!
DO NOT USE DIAMOND TIPPED DISCS OF
LOW QUALITY OR THAT ARE NOT SUITABLE
FOR THE SPECIFIC USE FOR WHICH THE
MANUFACTURER SUPPLIED THEM. THE USE
OF POOR QUALITY DISCS CAN HARM THE
OPERATOR AND DAMAGE THE MACHINE,
AS WELL AS SIGNIFICANTLY SLOWING THE
WORK.
cutter is used with
USE" paragraph.
DISC REMOVED.
CAUTION!
THE MACHINE IS NOT INTENDED FOR USE IN
AN EXPLOSIVE ENVIRONMENT
ALWAYS USE
DEVICES TO REDUCE THE RISKS CAUSED BY
WORK. NEVER START THE MACHINE WHEN
THE CUTTING TOOL IS MOVING; WAIT FOR IT
TO STOP.
Warning! When using electric tools, following
safety precautions should always be followed
to reduce the risk of fi re, electric shock and
personal injuries. Read and follow all these
instructions before attempting to operate this
product and save them with care!
SAVE THESE INSTRUCTIONS WITH CARE.
Keep your work area perfectly clean
- Cluttered areas invite injuries.
Consider work area environment
- Don't expose tools to rain.
- Don't use tools in damp or wet locations. Keep
work area well lit.
- Don't use tools in presence of fl ammable liquids
or gases.
Guard against electric shocks
- Prevent body contact with grounded surfaces.
Keep children away!
- Do not let third parties contact tool or extension
cord. All visitors should be kept away from work
area.
Store your tools in a save place
- When not in use, tools should be stored in dry
and save places, out of the reach of children.
Don't force tool
- It will function better and in a safer way at the
rate for which it was intended.
Use the right tool
- Don't use low duty tools or accessories to do
the job of a heavy-duty tools. Don't use tools for
purposes not intended.
38
CAUTION!
INDIVIDUAL PROTECTION