Connections; Connecting To Line Output (Pin Jack) Terminals Of The Amplifier - Yamaha YST-SW225 Mode D'emploi

Choose one of the following two connecting methods that is more suitable for your audio system.
■
Choose (pages 4-5) if your amplifier has line output (pin jack) terminal(s)
1
■
Choose (pages 6-7) if your amplifier has no line output (pin jack) terminal
2
Caution: Unplug the subwoofer and other audio/video components before making

connections.

Notes
• All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the
owner's manual of your component to be connected to the subwoofer.
• After all connections are completed, plug in the subwoofer and other audio/video components.

Connecting to line output (pin jack) terminals of the amplifier

1
• To connect with an amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc.) terminal on the rear of
the amplifier (or AV receiver) to the
• When connecting the subwoofer to the SPLIT SUBWOOFER terminals on the rear of the amplifier, be sure to connect
L
the /MONO INPUT2 terminal to the "L" side and the
SUBWOOFER terminals.
Notes
• Some amplifiers have line output terminals labeled PRE OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier has at least two sets of PRE OUT terminals. If the amplifier has
only one set of PRE OUT terminals, do not connect the subwoofer to the PRE OUT terminals. Instead, connect the
subwoofer to the speaker output terminals of the amplifier. (Refer to pages 6-7.)
• When connecting to a monaural line output terminal of the amplifier, connect the
• When connecting to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT
terminals on the rear panel of the subwoofer. If connected, they will not produce sound.
4
CONNECTIONS
L
/MONO INPUT2 terminal of the subwoofer.
R INPUT2 terminal to the "R" side of the SPLIT
L
/MONO INPUT2 terminal.