Control Displays And Symbols; How To Reload A New Probe Cover - Microlife IR 1DE1 Mode D'emploi

5.

Control Displays and Symbols

LCD Display Display
Meaning
All segments
displayed
Memory
Ready
Measurement
complete
Out-of-ear
temperature
indication
Low battery
indication
5
Description
Press the O/I button to turn
on the unit, all segments
will be shown for 2 seconds.
The last reading will be
shown on the display auto-
matically for 2 seconds.
The unit is ready for mea-
surement, the «°C» or «°F»
icon will keep flashing.
The reading will be shown
on the display with the
«°C» or «°F» icon steady,
the unit is ready for the
next measurement, when
the «°C» or «°F» icon is
flashing again.
A crossed-ear-icon is shown
on the LCD if the reading
falls outside the range 32.0
~ 42.2 °C / 89.6 ~ 108.0 °F.
When the unit is turned on,
the battery icon will keep
flashing to remind the user
to replace the battery.
EN
6.

How to Reload a New Probe Cover

(1) Place a probe cover onto
the storage case hole
with paper side upwards.
(3) Completely push the
probe into the probe
cover holder hole.
NOTE:
• In order to avoid cross-contamination, please reload a new probe
cover for each measurement.
• Please check if the probe cover is fitted on firmly before use
(please see the diagrams below); If the probe cover is broken,
discard the probe cover and reload a new one immediately.
(X) Incorrect
(2) Take the unit, vertically
penetrate the probe into
the center part of the
probe cover.
(4) Take out the probe with
cover attached tightly.
(O) Correct
6