Vulcan EV12 Mode D'emploi page 7

Installation of Legs/Casters:
1. Carefully tip or lift range to access bottom for leg installation.
2. Align holes in leg/caster mounting plate with pre-drilled holes in bottom of range located in each of the
four corners.
Attach mounting plate to bottom of range using four ¼ - 20 x ⅝ " self tapping screws (provided).
3.
casters are being installed, the locking casters should be mounted on the front.
4. After all legs/casters have been installed, carefully return the range to its upright position.
(For additional leg information, see Leveling section of this manual).
A permanently connected appliance mounted on casters and intended to be secured to the building structure
should adhere to the following:
a. Adequate means must be provided to limit the movement of the appliance without depending on or
transmitting stress to the electrical conduit;
b. The location(s) where restraining means are to be attached to the appliance needs to be on the outside
rear parts of the oven chassis frame of the Range.
supports, including thru holes and tapping holes for #10-24 screws.
included with caster accessory kits for attachment to the rear oven wall (screws not provided).
c. The appliance should be installed using a flexible conduit.
If the range is installed on casters and is moved for any reason, it is recommended that the range be re-leveled
front to back and side to side for even baking.
Attachment points are available on the riser
Strap clamps are also optional and
Strap Clamp
Riser Support
Rear Oven Wall
7
If
F-38251 (3-18) REV J