Proper Use; Package Contents; Features And Equipment - Indexa VF-140 Mode D'emploi

Operating instructions
GB
1. Introduction
Read through these operating instructions fully and carefully and while doing
so fold out page 3 with the illustrations. The operating instructions belong to
this product and contain important points concerning bringing the appliance
into service and its operation.
Always pay attention to all safety instructions. Should you have any questions
or be unsure about operating the appliance ask a specialist. Keep these
instructions in a safe place and should the need arise pass them on to a third
party.

2. Proper use

The wireless camera set consists of the camera VF-100K and monitorVF-140M
with two mains adaptors. It is to be used for the surveillance of rooms, entrance
hallways, driveways etc. through video pictures and sound. The video and
audio transmission is wireless using a frequency of 2.4GHz.
The monitor with integrated receiver can be connected to the video and audio
inputs of a monitor, TV-set or recorder. The power is supplied through the
supplied mains adapters connected to a 230VAC, 50Hz mains supply. For
temporary mobile use the camera can be powered by battery.
If there is sufficient light a colour picture will be transmitted. At low ambient
light levels the integrated Infrared LEDs are automatically switched on. In this
case the immediate area (within 5m indoors and 2m outdoors) will be
illuminated and the video picture switches to black and white mode for
improved light sensitivity. If the surveillance is specifically required in a dark
environment, then additional lighting should be installed.
Up to four wireless cameras VF-100K can be used with one monitor. The
camera channels can be manually selected or automatically displayed in
sequence if the scan mode is selected.
The camera is weatherproof (Protection class IP44) and can be used not only
indoors but also in a location outdoors which is sheltered from direct rainfall.
The receiver and both mains adapters are for indoor use only and must be
protected from moisture. The set is for use in private households. A video
surveillance system does not replace your duty of care or supervision. Observe
the regulations concerning video surveillance in commercial and public areas.
Any other use or modification of the device is not authorised. No liability will be
accepted for consequential damages or for damages caused by improper use or
incorrect operation. No liability will be accepted for consequential damages
caused by any function or by malfunction. Unless any liability is specifically
required by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the machine,
are excluded.
This appliance is not intended to be used by people (including children) with
restricted physical, sensory or mental capacities, or a lack of experience and/or
knowledge, unless they are supervised by, or receive instructions how to use the
appliance from a person responsible for their safety.

3. Package contents

!
VF-100K camera with connection cable to mains adapter
!
Monitor VF-140M
!
Mains adapter 7,5 V DC for camera
!
Mains adapter 7,5 V DC for monitor
!
AV-cinch cable
!
Camera bracket with screws and plugs
!
Monitor-wallbracket with screws and plugs
!
Battery connection cable
!
User manual

4. Features and Equipment

Camera VF-100K (s. Fig. A)
1 Camera
2 sunshield
3 Daylight sensor
4 Infrared LEDs
5 Mains adapter connection
6 Thread
7 Microphone
8 Rubber flap
9 Thread
10 Antenna
11 Channel selection button
12 Battery connection cable
13 Bracket
14 W ing screw
15 Triangular nut
16 Screws
17 Plugs
18 Mains adapter
Monitor VF-140M (s. Fig. B)
19 Monitor
20 Screen
21 on/off button
22 Audio-/Video-output
23 Mains adapter connection
24 Stand
25 Screw holes for wall bracket
26 Antenna
27 Wall bracket
28 Key-hole slot
29 Fixing hole
30 Plugs
31 Screws
32 Screws
33 AV-cinch cable
34 Mains adapter
35 "Auto"-button
(s. Fig. A and B)
GB - 19