Basic Function - Indexa VF-140 Mode D'emploi

11. Basic function

11.1 Volume setting
!
Set the required volume of the monitor loudspeaker [41] by pressing the
direction button [38] ( VOL- or
11.2 Monitor picture settings
!
Select the on-screen menu by pressing the Menu button [37].
!
Press the buttons [38]
!
Press the buttons [38]
!
Press the menu button again to exit the on-screen menu.
!
If no direction button is pressed with a period of approx. 20 seconds the on-
screen menu will be automatically exited.
BRIGHTNESS (0 up to 100)
CONTRAST (80 up to 100)
COLOR (0 up to 100)
SHARPNESS (0 up to 6)
12. Advanced functions using more than one
camera
12.1 Channel setting of the camera
The camera delivered in the set is already adjusted on channel 1. Should you
wish to change this channel or if you wish to use additional camera (maximum
3 additional cameras) proceed as follows:
13. Trouble shooting
Fault
Message"NO SIGNAL"
Unstable wireless reception
Flickering picture
Picture is too bright
Picture colours are not true, particularly in artificial
light
Picture colours are not true, eg. greenness of plants
22 - GB
VOL+).
and to select the menu points.
and to change the settings.
Cause
Incorrect channel selected
Camera not powered
The camera is out of range
Objects are preventing wireless connection
Receiver and camera too far apart
Wireless connection is blocked
Interference with wireless signal
Strong lightsource shining into the camera lens
Overexposure due to strong light source
The camera sensor is set for daylight
Thensor is also set for infrared light (for night vision).
This setting creates a shifting of the colour spectrum
!
Open the rubber flap [8] with a pointed object, pulling up from the left
hand edge.
!
Using a pointed object, eg. a ball point pen, push the channel selection
switch [11] to the required channel position (CH1/2/3/4). If more than
one camera are used than the camera channels must be different otherwise
the camera signals will interfere.
!
Press the rubber flap [8] carefully once more over the channel selection
switch (weather protection).
12.2 Manual channel selection
Press the channel selection button [36] repeatedly to scroll through the
channels.
12.3 Automatic channel switching
This function can be used when more than one camera is paired to the monitor.
!
Press the "auto" button [35], the "Auto" LED [40] will light up green.
!
Each time the channel selection button [36] is pressed the automatic
channel switching mode will be exited.
Remedy
Select correct channel by pressing button [36]
Check the mains adapter and cable connection.
Reduce the distance between camera and receiver
Remove large objects or change the location of camera and/or receiver
Reduce the distance between camera and receiver
Remove objects, in particular metallic objects and/or change the location
of camera and/or receiver
Check that there are no interference sources near camera and receiver eg
WLAN Router, elektrical produvts, Microwave ovens
Move the camera to another location
Change the direction or location of the camera
Further adjustment not possible
Further adjustment not possible