Installation; Rigging The 8Xt Or 108P Enclosure With The Etr8-2; Assembling - L-Acoustics ETR8-2 Manuel D'utilisation

6

INSTALLATION

6.1

Rigging the 8XT or 108P enclosure with the ETR8-2

6.1.1

Assembling

The ETR8-2 U-bracket is secured to the 8XT or 108P enclosure in the following way:
1. Remove the recessed set screw located on the top face of the enclosure.
Note: Put the screw in a safe place.
2. Remove the locking pin from the U-bracket and open the pivoting arm.
XTP_RM_ML_1.1
Recessed set
screw
Figure 8: Recessed set screw
Figure 9: Opening the pivoting arm
w w w . l - a c o u s t i c s . c o m
EN
13 en