Disassembling - L-Acoustics ETR8-2 Manuel D'utilisation

XT
COAXIAL RANGE -
rigging procedures
VERSION 1.1
3. a. Insert the enclosure's top face pole socket into the U-bracket's stud.
b. Rotate the pivoting arm into position: the spring-loaded pin will re-engage automatically into its initial position.
c. Select the desired enclosure's orientation and firmly screw the knob.
Verify that the pivoting arm is secured by checking that the spring-loaded pin is engaged
!
and that the pivoting arm cannot move freely.
Verify that the enclosure is secured to the U-bracket by checking that it cannot rotate freely.
WARNING
When installing the SB15P enclosure in the vertical orientation,
always position the ETR15P U-bracket with the fixed arm underneath the enclosure.
L-ACOUSTICS recommends using an additional safety point when rigging enclosures.
!
A safety eye-bolt accessory can be added using the M8* insert located on the rear face of the
SB15P enclosure (see Figure 19).
WARNING
* The "M8" notation refers to the European standard (see applicable external documentation).
6.3.2

Disassembling

Disassembling should be carried out in the reverse order of assembly.
XTP_RM_ML_1.1
P
SELF-POWERED COAXIAL RANGE
c.
b.
Figure 16: Securing the ETR15P to the SB15P enclosure
w w w . l - a c o u s t i c s . c o m
a.
18 en