Christopeit Sport FXM 2 Notice De Montage Et D'utilisation page 28

If you notice during training that the values which must be displayed by
the computers appear irregularly or the symbol "P" appears in the display,
conduct the following check procedure:
a. Check that the strap is not too loose and/or has slipped too far down-
wards.
b. Check whether the Christopeit-sport Brand on the transmitter of the pul-
se measuring unit is positioned correctly and is legible to a person looking
at the person in training.
c. Ensure that the computer is switched on.
d. Moisten the part of the strap neat the transmitter and which comes into
contact with the skin lightly with water to improve the transmission.
e. Check whether the battery in the transmitter is spent and change this
if necessary.
f. Remove and replace the batteries.
If you use both pulse measurements (you wear the pulse belt and put
the hands onto hand pulse sensors) the display will show the value of
hand pulse sensors.
Don't forget to press Start-key to start pulse measurement.
Cleaning, Checks and Storage of the Ergometer
bike:
1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene,
thinner or other aggressive cleaning agents for surface cleaning as
this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Plug out the power supply unit while intending the unit for more than
4 weeks not to use. Choose a dry storage in-house and put some
spray oil at front & rear foot tube connection point and hand grip
axle. Cover the bike to protect it from being discolor by any sunlight
and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for
tightness, which were prepared in the assembly. Every 100 operating
hours, you should put some spray oil at front & rear foot tube con-
nection point and hand grip axle.
Troubleshooting
If you cannot solve the problem with the following information,
please contact the authorized service center.
Problem Possible Cause
Computer has No power
no value at Dis- adapter is well
play if you press plugged or wall
any key. power is without
power.
Computer is Sensor impulse
not counting missing base on
data and do not not well plugged
switch on after connection
start cycling.
Computer is Sensor impulse
not counting missing base on
data and do not not correct posi-
switch on after tion of sensor.
start cycling.
No pulse value Pulse cable is
not plugged in.
No pulse value Pulse sensors
not well connec-
ted
28
Solution
Check that the power adapter
is properly plugged in, possibly
with another electric device
check if the wall power is fine.
Check the plug connections at
computer and inside of handle-
bar support.
Take off the cover and check
the distance between magnet
and Sensor. The magnet at
turning belt wheel should have
only less than < 5mm distance
against the sensor position.
Check the separately pulse
cable is well connected with
computer. Check the connec-
tions of the pulse cable.
Screw out the screw for pulse
measurement and check if
plugs are well connected and no
damage at pulse cable.