• put insulating material around the drawers,
e.g. blankets or newspapers.
Defrosting can be accelerated by placing
bowls with hot water (not boiling) inside the
freezer.
• Loosen the drainage channel from its rest-
ing position, push it in according to the il-
lustration and place it in the bottom freezer
drawer where water can collect
• carefully scrape off the ice when it starts to
thaw. Use a wood or a plastic scraper
• when all the ice has melted, clean and wipe
the cabinet dry, then put the drainage
channel back in place.
What to do if...
During operation of the appliance some
smaller but annoying trouble can often occur,
which does not require calling a technician
out. In the following chart information is given
about them to avoid unnecessary charges on
service.
Important! The operation of the appliance
goes with certain sounds (compressor and
Problem
The appliance is noisy.
The buzzer sounds. The
Alarm light flashing.
8) If foreseen.
Possible cause
The appliance is not supported
properly.
The cushion spacers located be-
tween the back of the cabinet and
the pipes come loose.
The temperature in the freezer is
too high.
The door is not closed correctly.
• switch on the cabinet, insert the plug into
the wall socket and replace the frozen
foodstuff.
Important! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long pe-
riods, take the following precautions:
• disconnect the appliance from elec-
tricity supply
• remove all food
8)
• defrost
and clean the appliance and all
accessories
• leave the door/doors ajar to prevent un-
pleasant smells.
If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the food
inside from spoiling in case of a power failure.
circulating sound). This not means a trouble,
but a normal operation.
Important! The appliance operates
discontinuously, so the stopping of
compressor does not mean being no
current. That is why you must not touch the
electrical parts of the appliance before
breaking the circuit.
Check if the appliance stands sta-
ble (all feet and wheels should be
on the floor). Refer to "Levelling".
Put them back in place again.
Refer to "HighTemperature Alarm".
Refer to "Door open alarm".
electrolux 23
Solution