Assigning The Channel Assignment For The Pan / Tilt Joystick; Joystick Direction Or Dmx Channel Inversion; Delete An Assignment; Reset To Factory Settings - involight Commander Série Mode D'emploi

1. Press / PATCH / for at least three seconds until the LED next to the button lights.
2. Use the joystick to select right and left the DMX channel you want to patch. Use Up and Down to select different
DMX areas. (See Section 2.2.3)
3. Press an AUX button to assign the DMX channel to it.
4. Repeat step 2-3 to patch additional channels.
5. When finished, exit Patch mode by pressing and holding down / PATCH / until the LED next to the button goes
off.

2.2.7 Assigning the channel assignment for the PAN / TILT joystick:

1. Press and hold the / PATCH / button until the control light comes on.
2. Use the / FIXTURE / 1-16 buttons to select the device to which the setting is to be assigned.
3. Use the joystick to select a DMX channel to which Pan or Tilt movement is to be assigned.
4. Press the / PAN / FADE / / TILT / WAIT / button. The display shows e.g.:
oder
5. Press and hold the / PATCH / key to exit patch mode.

2.2.8 Joystick direction or DMX channel inversion:

1. Press and hold the / PATCH / button until the control light comes on.
2. Use the / FIXTURE / 1-16 buttons to select the device whose pan or tilt movement you want to invert
3. Use the joystick to select a DMX channel to which the pan or tilt movement is assigned.
4. Press and hold the / PAN / FADE / / TILT / WAIT / button until an arrow appears in the display, e.g.:
or
5. Press and hold the / PATCH / button to exit patch mode.

2.2.9 Delete an assignment:

1. Press and hold the / PATCH / button until the control light comes on.
2. Select all devices (the / FIXTURE / 1-16)
3. Use the joystick to select a DMX channel whose assignment you want to delete. e.g.:
4. Press any / PRESETS / button. The display shows:
assignment is deleted.
5. Press and hold the / PATCH / key to exit patch mode.

2.2.10. Reset to factory settings:

Here, the device can be reset to the factory settings.
Note: All programs and headlight assignments are deleted!
1. Turn off the unit.
2. While holding down the / TAP / DEL /, / PROGRAM / REC / and / PATCH / buttons, turn the unit on. The display
shows:
25