Addressing The Devices In The Dmx Chain; Manual Setting Of Lighting Scenes - involight LEDCONTROL COMMANDER Série Mode D'emploi

Pin 3 pin international
1 Mass (shielding)
Signal inverted (DMX−)
2
3 Signal (DMX+)
Connect the DMX input of the unit to the DMX output of a DMX controller or other DMX device. Connect the output
of the first DMX device to the input of the second and so on to form a series circuit
From a cable length of 300m or after 32 connected DMX devices, the signal should be amplified using a DMX
splitter / repeater (e.g., Involight DMXS4, DMXS6 or DMXS8) to ensure error-free data transmission.
IMPORTANT: A terminating resistor should be connected to the end of the chain at the last device in a DMX chain.
DMX end resistors are commercially available, but can also be built by themselves. A 120 Ohm resistor must be
soldered in an XLR connector between the two poles (+ and -).

2.2.3 Addressing the devices in the DMX chain.

Before you begin, you must set the DMX start addresses of the headlights. It is possible to control up to 16
spotlights with up to 10 channels each, the "LEDControl".
The "LEDControl" assigns its DMX start addresses in 10 steps. This means that the devices must be set to the
appropriate start address so that the channel assignment of the faders is exactly correct. Devices that get the
same start address, of course, work synchronously (example: device 1 and 2 are both set to start address 1).
Explanation:
DMX device (spotlight, moving head, laser, light effect...)
Device 1
Device 2
Device 3
Device 4
Device 5
Device 6
Device 7
Device 8
Device 9
Device 10
Device 11
Device 12
Device 13
Device 14
Device 15
Device 16

2.2.4 Manual setting of lighting scenes:

In manual mode (Program LED off), you can choose the connected projectors manually and
control via the channel faders.
18
Start address
1
11
21
31
41
51
61
71
81
91
101
111
121
131
141
151