Addressing The Devices In The Dmx Chain - involight Commander Série Mode D'emploi

couplings are used as a connection.
A three-pin XLR socket serves as a DMX output, a three-pin XLR connector serves as a DMX input.
Pin 3 pin international
1 Mass (shielding)
Signal inverted (DMX−)
2
3 Signal (DMX+)
Connect the DMX input of the unit to the DMX output of a DMX controller or other DMX device. Connect the output
of the first DMX device to the input of the second and so on to form a series circuit
From a cable length of 300m or after 32 connected DMX devices, the signal should be amplified using a DMX
splitter / repeater (e.g., Involight DMXS4, DMXS6 or DMXS8) to ensure error-free data transmission.
IMPORTANT: A terminating resistor should be connected to the end of the chain at the last device in a DMX chain.
DMX end resistors are commercially available, but can also be built by themselves. A 120 Ohm resistor must be
soldered in an XLR connector between the two poles (+ and -).

2.2.3 Addressing the devices in the DMX chain:

The "LIGHTControl" has its DMX start addresses in 18 steps. This means that the devices must be set to the
appropriate start address so that the channel assignment of the faders is exactly correct. Devices that get the
same start address, of course, work synchronously (example: device 1 and 2 are both set to start address 1).
Explanation:
DMX-Device (Scanner, Moving Head, Laser, Lighteffect...)
Device 1
Device 2
Device 3
Device 4
Device 5
Device 6
Device 7
Device 8
Device 9
Device 10
Device 11
Device 12
Device 13
Device 14
Device 15
Device 16
22
Starting address
to be set
1
19
37
55
73
91
109
127
145
163
181
199
217
235
253
271