Applicable To Us/Ca Market - Husqvarna AUTOMOWER 105 Manuel D'utilisation

®
Automower 450X equipped with the
®
Automower Connect module also:
• ETSI EN 301 489-19 V2.1.0
•
ETSI EN 301 489-52 V1.1.1
• ETSI EN 301 511 V12.5.1
• ETSI EN 301 908-2 V11.1.1
For Husqvarna Automower
®
Automower 315, Husqvarna Automower
315X, Husqvarna Automower
®
na Automower 430X,Husqvarna Automow-
®
er 440 and Husqvarna Automower
equipped with Bluetooth
• ETSI EN 300 328 V2.1.1
• ETSI EN 301 489-17 V3.1.1
11.1 Supplier's Declaration of
Conformity
Issuer: Husqvarna AB, Drottninggatan 2, S-561
82 Huskvarna, Sweden
www.husqvarnagroup.com.
11.2 Compliance requirements
FCC ID: XPY1CGM5NNN (Automower
module).
FCC ID: ZASHQ-BLE-1A and FCC ID ZASHQ-
®
BLE-1B (Bluetooth
The Bluetooth module is located on the HMI-
board (PCBA) in the upper chassis. It must only
be accessed by an authorized service technician.
The device complies with part 15 of the FCC
Rules. Operation is subjected to the following 2
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING: To comply with RF
exposure requirements, please

28 - Applicable to US/CA market

®
310, Husqvarna
®
420, Husqvar-
®
450X
®
also:
11 Applicable to US/CA market
®
Connect
module).
Husqvarna 2018-10-01
Lars Roos
Global R&D Director, Electric category
(Authorized representative for Husqvarna AB and
responsible for technical documentation.)
®
maintain a separation distance of at
least 20 cm/ 7 inches from any part of
the product.
Models with a hatch: The supplied label shall be
attached to the product according to figure below.
Models without a hatch: The supplied label
shall be attached to the product according to
figure below
Husqvarna
Automower ® Connect
This device contains the module
FCC ID: XPY1CGM5NNN
903 - 001 - 21.09.2018