Applicable To Us/Ca Market; Compliance Requirements - Husqvarna AUTOMOWER 105 Manuel D'utilisation

11.1 Compliance requirements

FCC ID: XPY1CGM5NNN (Automower
module).
FCC ID: ZASHQ-BLE-1A and FCC ID ZASHQ-BLE-1B
®
(Bluetooth module).
The device complies with part 15 of the FCC Rules.
Operation is subjected to the following 2 conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
WARNING: To comply with RF exposure
requirements, please maintain a separation
distance of at least 20 cm/ 7 inches from any
part of the product.
Models with a hatch: The supplied label shall be
attached to the product according to figure below.
Husqvarna Automower
This device contains the module
FCC ID: XPY1CGM5NNN
Models without a hatch: The supplied label shall be
attached to the product according to figure below
Husqvarna
This device contains the module
FCC ID: XPY1CGM5NNN
Note: Changes or modifications made to this equipment
not expressly approved by Husqvarna may void the FCC
authorization to operate this equipment.
Note: This device complies with Part 15 of the FCC
Rules [and with Industry Canada licence-exempt RSS
standard(s)]. Operation is subject to the following two
772 - 001 - 29.05.2018

11 Applicable to US/CA market

®
Connect
Connect
®
Automower Connect
®
conditions: this device may not cause harmful
interference, and this device must accept any
interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Applicable to US/CA market - 25