Applicable To Us/Ca Market; Supplier's Declaration Of Conformity; Compliance Requirements - Husqvarna EPOS Manuel D'utilisation

9.1 Supplier's Declaration of
Conformity
Issuer: Husqvarna AB, Drottninggatan 2, S-561 82
Huskvarna, Sweden www.husqvarnagroup.com.
Responsible party: Husqvarna Professional Products,
Inc. 9335 Harris Corners Parkway Suite 500 Charlotte,
NC 28269 United States U.S. Contact information:
Michael Campbell, Sr Director Quality, test compliance,
Telephone: +1 704 597 5000.

9.2 Compliance requirements

FCC ID: MCQ-XBSX (Reference station).
FCC ID ZASHQ-BLE-1D (Bluetooth
The Bluetooth module and radio module are located
inside the reference station. They must only be
accessed by an authorized service technician.
WARNING:
exposure requirements, please maintain a
separation distance of at least 20 cm/7
inches from any part of the product.
Note:
Changes or modifications made to this
equipment not expressly approved by Husqvarna may
void the FCC authorization to operate this equipment.
Note:
This device complies with Part 15 of the FCC
Rules [and with Industry Canada licence-exempt RSS
standard(s)]. Operation is subject to the following two
conditions: this device may not cause harmful
interference, and this device must accept any
interference received, including interference that may
cause undesired operation.
Note:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1512 - 001 - 11.11.2020

9 Applicable to US/CA market

® module).
To comply with RF
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
WARNING:
Harm - www.P65Warnings.ca.gov.
Cancer and Reproductive
Applicable to US/CA
market - 11