Transportation, Storage And Disposal - Husqvarna AUTOMOWER 105 Manuel D'utilisation

6.1.1 Indicator lamp in the charging
station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing
green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light
Solid green light
Green flashing
light
Blue flashing light
Red flashing light
Solid red light

7 Transportation, storage and disposal

7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
• For how to remove the battery, refer to the
complete Operator's manual on
www.husqvarna.com.
7.1.1 How to lift and move the product
To safely move from or within the work area:
1. Press the STOP button to stop the product.
If security is set to the medium or high level
20 - Transportation, storage and
disposal
Cause
Good signals
The signals are good and
activated.
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Interruption in the charging station's an-
tenna.
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
Action
No action required
ECO mode is
No action required. For more informa-
tion on
Operator's manual.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Refer to complete Operator's
manual.
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire, and splice using an orig-
inal coupler.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
the PIN code has to be entered. The PIN
code contains four digits and is selected
when you start the product for the first time.
Refer to complete Operator's manual.
2. Set the main switch in position
105
3. Carry the product by the handle under the
product with the blade disc away from the
body.
ECO mode , refer to complete
0 .
310/315/315X
420/430X/440/450X
903 - 001 - 21.09.2018