Switching The Appliance Into The Standby Mode; Operating The Keys; Switching On The Hob And Cooking Zones; Switching Off A Cooking Zone - Bauknecht CTDI K 940C NE Instructions De Montage

Suitable for induction cooking
Operation

4.10 Switching the appliance into the standby mode

This standby key
nal. It is, as it were, the main switch. An automatic test of the
controls will be carried out fi rst of all, and the displays will light
up briefl y.
When the hob has been switched off with this key, it will re-
main on standby for approx. another 120 min.
Attention! The residual heat indicator will no longer operate
when the appliance has completely switched off .

4.11 Operating the keys

The controls described here expect the pressing of a (selecti-
on) key to be followed by the pressing of a subsequent key.
The next key will need to be pressed within 10 seconds,
otherwise the selection will be deleted.

4.12 Switching on the hob and cooking zones

1. Press the ON/OFF key
setting 0 appears and a short signal will sound. The cont-
rols are ready for operation.
2. The sensor fi eld
activated immediately afterwards. A power setting will be
switched on.
See the section on Worth knowing about the slider (sensor
fi eld)
Press the respective sensor fi eld
power setting or to switch on an additional cooking zone.
3. Immediately put cookware suitable for induction cooking
onto the cooking zone. The pan recognition device will ac-
tivate the induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the power level set and
the symbol . If no pot is placed on the cooking zone it
will switch off after 10 minutes for reasons of safety. Plea-
se refer to the Section on pan recognition.
4.13 Switching off a cooking zone
4. a) Press the touch control
b) drag your fi nger to the left across the touch control
to reduce the power setting to 0
c) press the ON/OFF key
right. All the cooking zones are switched off .
4.14 Switching off the hob
5. Press the ON/Off key of the hob
ched off , irrespective of any settings.
Please note:
The hob will switch off automatically after 10 seconds when all
the cooking zones are switched of manually (power setting 0)
and no key/sensor fi eld is pressed afterwards.
* The Power boost function is activated immediately.
See the section on Power setting.
is used to switch the entire hob operatio-
(approx. 1 sec.) until the power
of a cooking zone must be
left Power setting 0.
center Power setting 6.
right Power setting P*
on the far left or
of the cooking zones left or
. The hob will be swit-
GB
to change a
45