Operating The Hob With The Sensor Keys; Worth Knowing About The Slider (Sensorfi Eld) - Bauknecht CTDI K 940C NE Instructions De Montage

3.1 Operating the hob with the sensor keys

The glass ceramic hob is operated with touch control sen-
sor keys. The sensor keys are operated as follows: lightly
touch a symbol on the surface of the ceramic glass plate. A
buzzer will indicate when the controls have been operated
correctly.
The touch control sensor key will then be indicated as
"key".
Standby key (7)
This key is used to switch the entire hob operational. It is,
as it were, the main switch. When the hob has been swit-
ched off with this key, it will remain on standby for approx.
another 120 min.
Attention! The residual heat indicator will no longer operate
when the appliance has completely switched off .
ON/OFF key (8) Cooking zones left or right
This key is used to switch the respective cooking hob side
left or right on and off .
Power setting display
The power setting indicator shows the power setting which
has been selected, or:
...................Residual heat
...................Power boost
...................Pan recognition
...................Automatic boost function
...................Stop function
....................Keep-warm function
....................Control panel lock
Symbols
..........Keep-warm levels 42°C/ 70°C/ 94°C
...................Timer function, automatic switch-off device
...................Minute minder
..................Bridging function
Lock key (11)
The lock key can be used to lock all of the keys.
Keep warm key (12)
For melting, holding and simmering
Power boost in the sensor fi eld
The power boost setting makes additional power available
for induction cooking zones.
Stop key (14)
The STOP function can be used to briefl y stop the cooking
process.
Recall function (14) (recovery function)
The most recent setting can be recovered if the hob is
switched off unintentionally.
Minus key /Plus key
With this keys the power levels of the fan are selected and
the fan run is set.
42
Appliance description
(10)
Ventilation (20)
3.2 Worth knowing about the slider (sensorfi eld)
In principle, the slider functions the same as the touch
controls; the only diff erence is that you can put your fi nger
on the glass ceramic surface and then move it around.
The sensor fi eld recognises this movement and raises or
lowers the display setting (power level) in accordance with
the movement.
The term sensor fi eld is used to mean slider from now on.
Sensor fi eld
What must be observed when operating sensor fi elds?
Your fi nger should not be placed fl at onto the glass cera-
mic surface in order to avoid adjacent keys/sensor fi elds
from reacting by mistake.
unsuitable
Press the sensor fi eld lightly or move your fi nger
around
You can press the sensor fi eld very lightly with your fi nger;
when this is done the setting on the display (power level)
will gradually change.
When you put your fi nger on the sensor fi eld and then
move it to the left or right, the display setting will change
progressively.
The faster the movement, the faster the change in the
display.
touch
GB
right
move