Installing The Main Or Additional Intercom Panel - Philips WelcomeEye Comfort DES9500VDP - 531019 Notice D'utilisation

6 - Connect the 2 intercom panel wires and the 2 power supply wires in accordance with
the wiring diagram.
7 - Position the monitor on the wall bracket.
8 - Depending on the con guration selected, and when wiring is completed, the interface
may have to be con gured.
Warning: during this step, do not connect the power supply to the 230V AC.

4. Installing the main or additional intercom panel

Warning:
The product must not be connected to the power supply before wiring is complete.
1
4
DES 9900 VDP
5 3 1 0 0 6
1 2
1 2
1 2 3 4 5 6 7 8
1 2
DES 9900 VDP
CFI Extel
5 3 1 0 0 6
ZI de Fétan, 01600 Trévoux
FRANCE
20V 110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
2
5
2 1
2
8
WelcomeEye Comfort / Compact / 09/17
3
6
1
9
1m60
GB7