Installation Of A Cover Quick ® Wall In U Shape - Storch Cover Quick Wall Instructions De Montage

d) Installation and fixing of ceiling elements
Put together the two legs of the ceiling structure in the
same length as that of the floor structure, with T profiles
at both ends. Fix them hand-tight with locking screws.
Then connect the external T connection profile of the first
leg of the ceiling structure with the corner connector of
the side element and then stabilize this free-hanging part
by means of a telescopic support that you place between
the ceiling and the floor structure and then pull out.
Proceed similarly with the opposite side with the side and
ceiling element.
Then connect the two legs of the ceiling structure with a
corner connector which you secure with locking screws at
the T profile below the sealing lips.
e) Fine adjustment and securing
Proceed as outlined in point f of "Installation of the Cover
Quickwall wall separator".
®
In addition, clamp two 80 x 80 floor / ceiling seals in
the T-profiles to the rectangular joints of the floor and the
ceiling structure below the corner joints by putting the 80
x 80 corner seal with the recesses provided, over the T
profiles.
Installation of the Cover Quick Wall in U
®
shape
For this purpose, in addition to the basic set, the Cover
Quick Wall extension set (art. no. 56 55 10) is required.
®
When installing please follow the installation of the cor-
ner solution. The installation sequence is identical and
corresponds to a double corner solution.
49