Individual Elements Of The Cover Quick Wall And Their Function; Installation Of A Cover Quick Wall Room Separator - Storch Cover Quick Wall Instructions De Montage

Individual elements of the Cover Quick Wall and their function
®
T connection profile (25, 100, 150 cm)
Basically, for mounting on the ends of the created
structures or for subsequent mounting of the corner con-
nectors.
U intermediate profile (50, 100, 150 cm)
Structural element into which the T connection profiles
on both sides are slid and secured with locking screws.
Telescopic support (pull-out max. 380 cm)
For fixing of the structure and ensuring tightness by exer-
ting pressure on wall, floor and ceiling structures.
Corner connector
For connecting floor and ceiling structures with side
structures
For installing angled side, floor or ceiling structures
Installation only externally on the T connection profiles
Corner seal 70x70 mm
For tucking between floor or ceilings and walls and the
®
corner connectors of the Cover Quick Wall for sealing off
and providing additional protection for the surfaces
Corner seal 80x80 mm
For installing in rectangular floor and ceiling connections
(corner solution and double corner solution) under the cor-
ner connectors for sealing off the structure
Installation of a Cover Quick Wall room separator
®
a) Defining of the area to be separated
For this purpose, put the T and U profiles on the floor in turns, stick them together and pull them out to the desired
length.
b) Assembly of floor and ceiling elements
Required elements for the installation width of up to
5,30 m:
1 x T connection profile 150
2 x T connection profile 100
1 x U intermediate profile 150
1 x U intermediate profile 50
Make sure that a T profile is placed at each end, where
you attach a corner connector outside of the profile.
Pull the structure apart so that the corner connectors are
as close as possible to the walls. Then tighten the locking
screws hand-tight.
45