Changing The Opening Direction Of The Doors - Whirlpool ADN 270S Mode D'emploi

CHANGING THE OPENING DIRECTION OF THE DOORS

See fig. 5, page 2
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the
refrigerator horizontally!
Warning: Always disconnect the unit from the mains before any maintenance or repair
work is carried out.
Before you start, please note the following:
∙ Always ensure that the correct number of washers is used on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take the utmost care that they are
properly aligned during reassembly.
1. Remove covers c from the inside of the housing and door and the upper bracket 6
together with the nut and washers and the gasket under the bracket. Remove the
refrigerator door.
2. Remove the bottom cover 1.
3. Unscrew the shaft 2 from the lower bracket 7. Screw it together with all the washers
into the bracket 7 on the other (opposite) side, symmetrically to the former position
(see figure). Slide the door onto the 7 axles of the bracket.
4. Rotate the bracket 6 with the washers on the shaft and the plastic gasket at an angle of
1800, unscrew the shaft together with the washers and screw in on the opposite side
of the bracket. After inserting the bracket 6, screw it into the refrigerator compartment
door on the opposite side of the refrigerator in the upper holes.
5. Cover the bracket and the remaining empty cavity with lids c.
6. Remove the screw caps a and the blinds b. Unscrew the screws securing the handles.
Move the handles in the opposite direction and tighten. Press the blinds into the
remaining holes in the door and place the covers on the screws.
7. Remove the cover 10 from the lower cover 1 and insert it into the guides on the other
side of the lower cover (symmetrical to the previous position). Insert the left and right
legs of the lower cover 1 into the holes (see figure) and slide until the cover locks in
place.
OPERATION PROBLEMS AND THEIR SOLUTIONS
The appliance is plugged in to the mains but it does not work. Check that your
•
house electricity supply installations are in order.
inserted into the electricity supply socket.
The noise has become louder. Check that the appliance is standing stable, on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching any
furniture, and that no part of the refrigeration system at the back part of the appliance
body is touching the wall. Pull the appliance away from any furniture or walls. Check
that the cause of increased noise isn't due to bottles, cans or dishes in the appliance that
might be touching each other.
Water has appeared at the bottom of the refrigerator compartment. Check
•
whether a thaw water channel space isn't blocked. Clean the thaw water channel space
with a cleaner intended for that purpose.
Check that the plug is correctly
9