_______________________________________________________________
horizontal position with the aid of the flipping
mechanism.
Lock all casters in place
Take a firm hold of the tabletop
Use your foot to move the lower lever against
the stop
or
Use your hand to move the upper lever against
the stop
=
The tabletop lock is released
Use your foot to press against the tabletop
while simultaneously using one hand to pull the
upper tabletop area towards you until the
tabletop has reached the horizontal position
and snaps in place.
When the tabletop has reached the
correct position, it will snap in place.
5.3 Placing the tabletop in
vertical position
Risk of physical injury!
A rolling-away conference table / training
room table with an unlocked tabletop can
cause physical injury.
Lock all casters in place before
engaging the lever.
Figure 5-2: Work surface can be flipped either way
10
Operation and adjustment
The tabletop of the FlipTop Twin conference table
/ training room table can be brought to the vertical
position to save space.
Remove all objects from the tabletop of the
conference table
Disconnect the power set connector from the
mains
Lock all casters in place
Take a firm hold of the tabletop
Move the lever under the tabletop against the
stop
The tabletop lock is released
=
Raise the tabletop and push it towards the rear
while simultaneously using your foot to press
against the lower tabletop area until the
tabletop has reached the horizontal position
and snaps in place.
When the tabletop has reached the
correct position, it will snap in place.
A flipping mechanism is located on both
sides of the conference table / training
room table.
5.4 Adjusting casters
Figure 5-3: Adjusting and locking the casters
The tabletop height can be increased by 10 mm by
adjusting the casters.
Engage the arresting elements to adjust the
table to the preferred height.
The caster can be fixed in place by locking the
arresting element.
Push down the arresting element until it locks
in place.
156562