Receiver Station - Renkforce BM-7200 Notice D'emploi

a) Receiver station
• Erect the ANT-A (13) and ANT-B (8) antennas vertically (90°). Depending on the position of the receiver station,
angling the antennas might be useful for improving reception.
• Set the POWER on/off button to I position to turn on the station. The LC display (7) lights up. The receiver station
is ready for use.
• Set the POWER on/off button to 0 position to turn off the receiver station.
• Adjust the volume for audio channel A (CH.A) and audio channel B (CH.B) using the respective volume controls
VOLUME.A (4) and VOLUME.B (4).
• Audio channel A and audio channel B can be adjusted independently. Refer to below description of the LCD.
LCD:
Audio channel A (left)
RF: Radio signal strength
AF: Audio signal strength
Channel and channel
number
Identification symbol of an
audio channel
Appears, when a transmitter
is paired
Pairing symbol: Flashes
during pairing
Displayed when searching
free frequencies
Locking/unlocking buttons
• Press and hold the SET button (1) until
adjustments.
• If there is no input for approx. 6 seconds, all buttons will be locked automatically.
- The symbol lights up in the LCD when the buttons are locked.
32
Audio channel B (right)
Frequency display
in MHz
Battery charge status of the
paired device
Transmission power
low (LO) / high (HI)
Control buttons locked
(preventing incorrect inputs)
starts flashing. It is then possible to use the buttons for making