Troubleshooting - Renkforce BM-7200 Notice D'emploi

Wireless microphone/pocket transmitter (with headset):
Observe some notes on using the wireless microphone and the pocket transmitter (with headset):
Do not bring the activated microphone close to a paired speaker, in order to avoid feedback.
• Do not hold the wireless microphone by the grille (19) when in use, but place your hand on the sleeve (15).
• When using the wireless microphone, the distance to the mouth should not exceed 15 cm.
• Do not hold or bring two activated microphones close to each other.

12. Troubleshooting

Problem
No function after the POWER
on/off button on the receiver
station has been turned on.
The receiver station is turned
on, but there is no sound.
Audio distortions
No sound temporarily.
Noise/signal distortion
36
Possible cause
The power adapter is not properly
connected to the wall socket.
The connection cable of the mains
adapter is not properly connected to the
mains socket DC INPUT.
No power supply at the wall socket.
The receiver station is not properly
connected to the downstream audio
device.
The wrong input has been selected on
the downstream device.
Wrong channel on the receiver station.
Volume adjusted improperly.
Volume control of the receiver station or
other volume controls set to zero.
Improper setting of the signal
amplification on the connected audio
device.
Dead spot prevents reception.
Another wireless device affects the
transmission.
Possible solution
Check the connections and make
sure the receiver station is supplied
with electricity.
Check all sockets for correct
connection and allocation.
Turn on a transmitter.
Adjust the volume properly.
Adjust the amplifier or mixer
properly.
Avoid walking into such a spot
when using the microphone.
Avoid operating other devices on
the same frequency band.