Inserting Batteries; Wireless Microphone; Pocket Transmitter; Operation - Renkforce BM-7200 Notice D'emploi

10. Inserting batteries

When inserting the batteries, observe the polarity markings inside the battery compartment.
Replace the batteries by new ones of the same type, once the device does not function or turn on anymore.
Remove the batteries from the battery compartment when not using the device for a longer period of time,
in order to prevent leaking.
The symbol indicates that the batteries in the wireless microphone and pocket transmitter are
discharged. Replace discharged batteries by new ones.
a) Wireless microphone
• Turn the sleeve (15) anticlockwise to uncover the battery compartment.
• Insert two batteries of type AA into the battery compartment (14).
• Reattach the sleeve and tighten it slightly.
b) Pocket transmitter
• The battery compartment (23) is integrated in the front of the transmitter.
• Slightly press the two lateral grip surfaces on the battery compartment lid (24) marked with
the lid towards the front. The battery compartment is open.
• Insert two batteries of type AA into the battery compartment.
Remember the position of the IR sensor iR (25) that you will need later for facilitating the connection.
• Close the lid. Make sure the lid locks into place.

11. Operation

Set the volume controls of all devices to zero before connecting the receiver station to the
mains and turning latter one on. Non-observance of this instruction can cause damage.
• It is possible to play back both the wireless microphone and pocket transmitter (with headset) at the same time.
- Channels CH.A and CH.B are required for that purpose.
- In doing so, two separate channels will be allocated to the wireless microphone and pocket transmitter.
• The audio channels CH.A and CH.B feature independent volume control settings each.
• Pairing the wireless microphone and pocket transmitter (with headset) with the receiver station can be achieved by using
the IR sensors iR.
Before disconnecting audio devices, set all volume controls to zero and turn off the receiver station.
, and then and pull
31