Sony MPK-DVF6 Mode D'emploi page 8

Preparations (continued)
For DCR-TRV30/TRV30E/TRV20/TRV20E/TRV17/TRV17E/TRV15/
TRV15E/TRV11/TRV11E/TRV6/TRV6E
Use camera mounting shoe B and D, cushions for camera mounting shoe D and the
screw plate.
Before attaching the camcorder
Check the cushions for camera mounting shoe D and the installing position of the
screw plate for your camcorder against the table below.
Remove the stick tape from the
cushion for camera mounting shoe
D. Then stick the cushion for
camera mounting shoe D onto
camera mounting shoe D as shown
in the illustration.
1 Attach the screw plate to the
2 Fasten the screw of the screw
3 Attach the screw plate to the
4 Fasten the screw of the screw
5 Connect the A/V connecting
8
-GB
Camera
DCR- mounting mounting
TRV30/TRV30E
TRV20/TRV20E
TRV17/TRV17E/
TRV15/TRV15E
TRV11/TRV11E/
TRV6/TRV6E
position on shoe D so that the
catch on the reverse side of the
shoe D clicks into place.
The installing position of the
screw plate differs on your
camcorder. For details, refer to
the table above.
plate on shoe D to the tripod
screw hole of the camcorder and
tighten firmly.
position 2 on shoe B.
plate on the shoe B to the screw
hole on the shoe D of the
camcorder tightly.
cable of the shoe to the
camcorder's AUDIO/VIDEO
jack.
Camera
shoe B shoe D
2 1
2 1
2 3
2 2
Cushion
Thick
Thin
Thin
Thin
Installation
position
of the screw plate
of the camera
mounting shoe D
Screw plate
Camera mounting
shoe D
Camera mounting
shoe B
Screw plate