Technical Features; Where To Locate - Indexa DA02 Mode D'emploi

GB
Ready to use everywhere – very easy to install
At home, in a shop or in an office, the ceiling alarm is immediately ready to use. The built-in passive
infrared motion detector (PIR) reacts to body heat. The alarm is activated as soon as somebody enters
the PIR range. The ceiling alarm can easily be switched on and off with the remote control. Use the
ceiling alarm to secure rooms. The unit is powered by batteries, but can also be powered using a mains
adapter.

Technical features

connection for
mains adapter
alarm unit
Technical features
Alarm unit DA02
Power supply:
Power consumption:
Sensor:
PIR range:
Alarm siren:
Control system:
Field of application:
Operating temperature:
Remote control FB02
Type:
Power supply:
Additional remote controls (FB02) are obtainable.

Where to locate

!
Look for a suitable place on the ceiling. Optimal
function is at a height of 2,5 m.
!
Locate the unit at a place where most of the
movements are transverse to the PIR. These
movements can be detected more quickly than
movements towards the PIR (Fig. 1).
!
The unit should not be exposed to direct sun light or
artifical light as this can cause false alarms and reduce
green LED
red LED
receiver for
remote control
4 x C batteries (alkaline) 1,5V (LR 14) or
mains adapter 9V,
(Art.Nr. 32108)
1,5 mA (stand-by), 120 mA (alarm)
Passive infrared motion detector (PIR)
360° over a diameter of approx. 6 m (mounting height 2,5 m)
piezo alarm 100 dB(A)
Infrared remote control
Use only in dry locations, protect unit from moisture and frost.
0°C – 30°C, Optimal function at room temperature (20°C). Very high or
low temperatures can be detrimental to the function of the unit,
especially when battery operated.
Infrared Ch. B
1 x 12V battery, type 23 A (lighter cell)
red
LED
ON/OFF
button
remote control
(battery included)
min. 200 mA (inner pole of the plug negative)
2 screws mounting
2 pegs
less
sensitive
sensitive
2,5 m
6 m
fig. 1
fig. 2