First Starting; Manual Start - glass 1989 LIS Manuel D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
- After the installation, check that the bathtub is clean. Fill it up with water at 40+/-5°C
up tp the highest jet level that allows the system functioning.
- Start the system and let it running for 10 minutes minimum. If the product is equipped
with a varying speed pump, activate the minimum/maximum cycle at least once during
the checking. Without draining the bathtub, stop the hydromassage system and after
10 minutes minimum, check all the piping, the joints and the connections to find any
water leaks.
- Make sure that water has covered the jets.
- Make sure that the jets are open, otherwise turn the diffuser anticlockwise (Figure 3).
- By turning the ring from "O" to "I" (detail 1 figure 4) the hydromassage system
starts.
- Adjust the air flows by turning the ring clockwise or anticlockwise ( detail 2 figure 4)
on the symbol "
- To stop the hydromassage system turn the ring on the "O" symbol (detail 3 figure 4).

FIRST STARTING

MANUAL START

".
FIGURE 4
9
FIGURE 3
GB

Publicité

Table des Matières
loading

Table des Matières